Tinte a base de agua

Infinity Tools stocks 27 General Finishes water-based products including dye stains in colors like Amber, Blue, Cinnamon, Brown, Ebony, Empire Red, Green, Merlot, Pecan, and more, plus a Pre-Stain Conditioner and Dry Time Extender. Browse the full water-based stain collection.

A water-based dye stain contains molecules small enough to penetrate directly into wood cell walls, producing transparent, vibrant color that showcases grain figure. A pigment stain contains suspended particles that lodge in pores and surface texture, producing more opaque color with less grain definition. Dyes are generally preferred on figured or highly decorative wood.

Yes. Water-based stains have very low VOC content compared to oil-based alternatives, making them safer to use in enclosed spaces. Always maintain adequate ventilation during application and drying, but the odor and air quality impact is far lower than with solvent-based stains.

General Finishes water-based dye stains typically dry to the touch within an hour or two under normal indoor conditions (70°F, moderate humidity). Recoat or topcoat times vary by product—always check the specific product's data sheet for current recommendations.

On blotch-prone species like pine, maple, cherry, and birch, applying the General Finishes Pre-Stain Conditioner before staining promotes more even absorption and reduces splotchy results. On open-grained hardwoods like oak or ash, conditioning is generally not necessary.

Yes. General Finishes water-based dye stains are intermixable within the same product line. Mix colors thoroughly before applying and always test your custom blend on scrap wood from the same board, as the color will shift when dry and again once a topcoat is applied.

A water-based topcoat is the easiest and most compatible choice—General Finishes High Performance Top Coat is a popular pairing. You can also use an oil-based topcoat as long as the stain is fully dry, but water-based stains and water-based topcoats from the same product family always have guaranteed compatibility. See our top coat collection.

The General Finishes Dry Time Extender is an additive mixed into water-based stains or finish coats to slow their drying time. It's useful when brushing large panels where fast drying can create lap marks at brush joins, or when spraying in warm, dry conditions where the material dries before it can atomize properly.

Gel stain generally outperforms water-based liquid stain for blotch control because its thick consistency limits deep penetration, producing more even surface color on difficult species. For maximum blotch control with water-based stains, use a pre-stain conditioner. See gel stains as an alternative if blotching remains an issue.

Yes—water-based stains are among the more forgiving finishing products for beginners. The short dry time means mistakes are visible quickly, and if needed, the stain can be wiped off while still wet with a damp cloth. Using a pre-stain conditioner, testing color on scrap first, and working in manageable sections keeps results consistent. The Infinity Tools learning blog has additional guidance on wood finishing technique.